In the application of insulated terminals, we need to perform corresponding crimping detection before use to ensure our own safety during use, and fully understand that insulated terminals can avoid some related problems. The following is the introduction to the crimping detection of insulated terminals:
1. Selection of specifications. Before using insulated terminals, you need to select the specifications of the terminals, and in a specific environment, you need to choose the specifications that can be applied to the scene, so as to ensure the effective operation of the circuit and our own safety, therefore, it is necessary to choose the correct specifications.
2. Strip the length of the wire. When using insulated terminals, peel off the wires with insulation shells. The length of the peeled wires must be able to be fully wrapped by the terminals. At the same time, before use, it is necessary to observe whether the copper wire is scattered, which can avoid unnecessary problems when we use it and protect our safety.
3. Check whether the position of the terminal crimp is correct. Check the result of the terminal with the strength test table of the product, and judge whether it can be used effectively by the size displayed. For a scenario that requires the use of full terminals, inspection and post-maintenance are key steps in using this product.
4. Withstand pressure test. Through different degrees of voltage resistance test, to observe whether the insulation terminal as a whole has a rough phenomenon, these subtle problems will also affect the safety and effective operation of the circuit.
To sum up, it is very necessary to pay attention to crimping detection in use, and to understand the characteristics of the product in this way, so as to use it safely and effectively.
